Page 3 of 3

Re: Anyone put up any tongue and groove pine?

Posted: Thu Aug 17, 2017 3:09 pm
by tom4018
dieselbeef wrote:lookie there

What?

Re: Anyone put up any tongue and groove pine?

Posted: Thu Aug 17, 2017 3:18 pm
by 4x4dually
dieselbeef wrote:lookie there


Ya, I had a bull question, so I re-appeared on here today. Something about his rear end falling out. LOL

Re: Anyone put up any tongue and groove pine?

Posted: Thu Aug 17, 2017 4:17 pm
by Nesikep
My friend just is putting up T&G pine.. his is 4 sided T&G, so the ends match up very nicely.. A bead of glue on the studs, finish nailer on an angle into the tongue.
For sawing, a good radial arm saw or miter saw with a fine toothed blade works very nicely

Re: Anyone put up any tongue and groove pine?

Posted: Fri Sep 22, 2017 6:43 am
by tom4018
For those that put it up did you sand it very much before finishing it? If so what type sander did you use?

Re: Anyone put up any tongue and groove pine?

Posted: Fri Sep 22, 2017 9:27 am
by tja477t
i always cut the ends at an angle so when you butt them up there is always wood showing. plus if it dries out some there isnt a gap where they come together.

Re: Anyone put up any tongue and groove pine?

Posted: Fri Sep 22, 2017 10:39 am
by tom4018
tja477t wrote:i always cut the ends at an angle so when you butt them up there is always wood showing. plus if it dries out some there isnt a gap where they come together.

We did do that also.