- Posts: 164
- Joined: Thu Nov 21, 2013 6:11 pm
- Has thanked: 1 time
- Been thanked: 4 times
I have wired up driving lights on my Kubota. I ran a commercial wiring loom supplied with the light bar from the battery it went as far as under the seat. Then I have extended it up the roll bar and split it so that it fed the light bar on the front and 2 x square LED lights on the back. It's fused at the battery.
Because I I lack a little confidence at this point in my life I feel worried it's not good enough. There should be no problems should there and if there was a short of a problem the fuse would safe quard me?
- Posts: 18834
- Joined: Thu Jul 05, 2012 5:51 pm
- Location: Cleveland Tx
- Has thanked: 121 times
- Been thanked: 550 times
Power corrupts. Absolute power corrupts absolutely.
It ain't easy being a used cow salesman.
- Trail Boss
- Posts: 481
- Joined: Fri Oct 14, 2016 8:44 am
- Has thanked: 2 times
- Been thanked: 40 times
As long as that is done there is nothing to worry about.
- Posts: 15070
- Joined: Sat Dec 13, 2008 9:37 pm
- Location: Lillooet, BC, Canada
- Has thanked: 821 times
- Been thanked: 628 times
Yup, I'd draw off ignition hot if you have a habit of being forgetful.. nothing worse than a dead battery
LED lights don't need a lot of power, most of them are 1-2 amps each with bigger LED bars being about 10 amps max.. At this power draw relays are usually not needed.