Page 4 of 4

Re: Hay rings with the skirts at the bottom ?

Posted: Sun Jan 20, 2019 8:31 am
by slick4591
sstterry wrote:
slick4591 wrote:I priced the Century cone feeder yesterday and at $720 it will have to wait until I get a couple calves sold.


After hearing how hard the regular ones are to assemble, you had better make sure that bad boy is assembled when you get it!


I didn't think to ask while I had the sales guy on the phone, but I do own a drill and bits in case it's not. :lol:

Re: Hay rings with the skirts at the bottom ?

Posted: Mon Jan 21, 2019 6:29 am
by cfpinz
elkwc wrote:Ordered the bar kit for the Century feeder today. I was driving but think it was $56.00. Should have it next week.


Thank you. I need to get off my butt and order some.

Re: Hay rings with the skirts at the bottom ?

Posted: Tue Jan 22, 2019 7:35 pm
by elkwc
cfpinz wrote:
elkwc wrote:Ordered the bar kit for the Century feeder today. I was driving but think it was $56.00. Should have it next week.


Thank you. I need to get off my butt and order some.


Got mine today. Hopefully will get them installed in a few days.

Re: Hay rings with the skirts at the bottom ?

Posted: Wed Jan 23, 2019 6:10 am
by cfpinz
Got down to 10F here the other night and froze the ground pretty well, finally! The poly feeders were easy enough for me to break loose from the frozen ground by hand and move to another location. The steel rings are still sitting in the same place, couldn't break them loose by hand and afraid the truck would destroy them. Just something else to consider.