Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Discuss your favorite brand and how to fix it.
- Posts: 1431
- Joined: Sun Jul 07, 2013 5:05 pm
- Location: Southwest Va
- Has thanked: 88 times
- Been thanked: 35 times
My 554xl has the basic Acutie monitor with it. Does anyone know anything about these and how to trouble shoot. My give all kinds of error codes. It thinks the bale has reach the preset size as soon as the roll starts sometimes. Then it thinks the roll has meet the oversize roll size then starts tying. It also gives a error that there is a short in ground on the tie arms. I have looked over all the wiring and can not see any bad wires. Iam thinking maybe it’s the monitor it self because of all the different codes it is throwing. Anyone have any ideas ? Yesterday when I was rolling the monitor would turn it self off and would not tie a roll. Lucky I was able to unhook it and tie them manually with just a toggle switch
- Posts: 8983
- Joined: Sun Feb 03, 2008 7:57 pm
- Location: Central Texas
- Has thanked: 100 times
- Been thanked: 166 times
Could be the pins in the connectors. My controller stoped auto tying. Traced it down to the loose connector.
Aug 7, 2019 22:51GMT -5 the illustrious potentate said:
Because you have the freedom to say what you think, doesn't always mean that you should.
The right to speak freely is not free of consequences.
- Posts: 515
- Joined: Fri Oct 14, 2016 8:44 am
- Has thanked: 3 times
- Been thanked: 50 times
I would check over the ground wires. Make sure the one from the monitor to the tractor battery is good and tight, and the one from the monitor harness to the baler chassis is good. Bad grounds can cause some very odd issues.
- Posts: 3523
- Joined: Sun Aug 25, 2013 9:04 pm
- Location: Virginia
- Has thanked: 367 times
- Been thanked: 375 times
Last year I had to replace the sensor on the bale size indicator on my Vermeer and this year I had to replace the sensor on the tying arm. I looked the wiring over and imagined everything. After replacing those it was instant fix. If the monitor will boot up ok and give an error code it may not be it, although I am not an expert on them. As mentioned I would check the pins closely as I spray WD-40 on mine often and it helps lube and clean the pins for a smoother fit.
Just a SWAG it sounds like the bale size sensor on the variable chamber arm.